INDUCTIVE LOADS CONTINUOUSLY VARIABLE
Nucon Single & Three Phase Inductive Loads
are very useful for Electrical Engineering Labs. Electrical Test Houses
and Industries.
MAIN FEATURES
The Coils are wound on Fiber Bobbins with best quality Super Enamled
Copper Wire. The Core is hot rolled steel, Sillicon Coated having low
hysterisis & low eddy current losses. One core is tightly fixed into the
lower side of the Coil and the second core slides in the remaining
portion of the coil through the bobbin, making close Magnetic circuit.
The core sliding system is provided with a Fine Threaded Steel Rod,
moving in a Gun Metal Block to give very fine regulations. The block is
fitted to the sliding core and a Hand Wheel is fitted to the rod (Lead
Screw) to move the core up and down inside the Magnetic Coil to give
very fine variation of Current. The unit works on AIR GAP PRINCIPAL.
With increase of the air gap the current decreases. The cores are
tightly bound to reduce the resonance when core slides inside the the
Magnetic Coil & current is maximum.
This whole is fitted in a metal box, provided with four Castor Wheels to
make it a trolly. Finished in Duco Paint the box is provided with
bakelite Panel, fitted with non-flying type insulated brass terminals.
NUCON INDUCTIVE LOAD single phase 50
Hz. 220/230 Volts. specifications as mentioned above. Two Terminals are
provided on the panel Continuously variable.
Lagging Power Factor : 0.2.
Max. Current 4 Amp. 5 Amp. 8 Amp. 10 Amp. 15 Amp. 20 Amp.
INDUCTIVE LOADS : THREE PHASE 50 Hz. Three limb Core type,
400/415V.
Line Voltage 230/240 Volts. Specifications as described above.
Six Non Flying Type Insulated Brass Bakelite Moduled Terminals are
fitted on the panel to use
the unit as explained below :
i) In Star for 400/415 V. 3 Phase line System.
ii) The Delta for 230/240V. 3 Phase Line System.
iii) The three Inductive Coils can be connected in series.
The Terminals are marked and complete operating instructions are
engraved on the panel.The Inductive Load are manufactured in the
following ranges.
Max. Current/Phase 5 Amp. 8 Amp. 10 Amp. 15 Amp. 20 Amp. 25 Amp
Three & Single Phase Inductive Loads
can be supplied with Meters to read Voltage & Current at the following
extra prices.
|